DEVELOPMENT OF PROTEUS V7.10 BOOKLETS FOR ELECTRONIC TECHNIQUES COURSE MODULES IN PTE FT UNY

Abstract

The problem in this research is the unavailability of interesting learning media that supports the learning process in the Electronics Engineering Education Department of Yogyakarta State University. This research aims to develop print-based learning media in the form of booklets in the Electronic Engineering Drawing course with Proteus software in accordance with the basic Proteus material.
This development research was done in the Electronics Engineering Education Department. This research used the 4D method (four-D) which is carried out through four main stages, namely the defining process, the design process, the develop process, and the dissemination process. This research used a questionnaire as a tool to test the feasibility of learning media obtained from material experts, media experts, and related course teachers.
The development results obtained by learning media products in the form of a basic guide booklet drawing with Proteus software. The booklet consists of three main parts, namely, introduction, contents and closing. Assessment by material expert lecturers gets a percentage of 85% with the title "very feasible". Assessment by media expert lecturers gets a percentage of 86% with the title "very feasible". Thus, a print-based learning media in the form of a basic guide booklet drawing with Proteus software is feasible to use for the learning process.

Keyword : Learning Media, Booklet, Proteus Software